Advertisement
Advertisement
Table of Contents
Related Manuals for Samson AirLine 88 Series
Summary of Contents for Samson AirLine 88 Series
- Page 1 OWNER'S MANUAL...
- Page 2 Copyright 2019, Samson Technologies Corp. This product is covered by the US patent: US9,602,053 Samson Technologies Corp. 278-B Duffy Ave Hicksville, NY 11801 www.samsontech.com...
-
Page 3: Important Safety Information
Important Safety Information ATTENTION RISQUE D’ÉLECTROCUTION ! NE PAS OUVRIR ! CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of non-insulated “dangerous voltage”... - Page 4 Important Safety Information 13. Unplug the apparatus during lightening Read these instructions. storms, or when unused for long periods Keep these instructions. of time. Heed all warnings. 14. Refer all servicing to qualified personnel. Follow all instructions. Service is required when the apparatus has been damaged in any way, such as Do not use this apparatus near water.
- Page 5 Important Safety Information FCC Rules and Regulations Samson wireless receivers are certified under FCC Rules part 15 and transmitters are certified under FCC Rules part 74. Licensing of Samson equipment is the user’s responsibility and licensability depends on the user’s classification, application and frequency selected.
- Page 6 Samson products in the future. Also, be sure to check out our website (www. samsontech.com) for complete information about our full product line.
-
Page 7: Quick Start
Quick Start In order for your wireless system to work correctly, both the receiver and transmitter must be set to the same channel. Follow this basic procedure for setting up and using your AirLine 88x Guitar wireless system: Physically place the CR88x receiver where it will be used, and extend the antennas vertically. The general rule of thumb is to maintain “line of sight”... - Page 8 Quick Start Press the SCAN button for more than 2 seconds (the display will start to flash quickly) on the front of the CR88x receiver to scan for an available channel. Once the optimal This device complies with Part 15 of the FCC Rules.
-
Page 9: Multiple System Setup
Quick Start - Single System Setup When the transmission is complete, the CR88x will receive RF signal and the tone key from the trans- mitter. The READY indicator will light on the front panel of the CR88x receiver. Turn on your connected amplifier or mixer, but keep the volume all the way down. - Page 10 Setting the Plug for your Guitar The AG8 plug can be configured for Fender Stratocaster™-type (angled) recessed jacks, and in a second position designed to be used with all other instruments that have end mount-jacks. To configure the AG8 for Fender Stratocaster™...
- Page 11 AG8 Callouts 1/4” Phone Plug - Insert this standard 1/4” plug into your electric guitar or electric bass. Note that the position of the plug can be configured for Fender Stratocaster™ type recessed jacks, and in a second position designed to be used with all other instruments that have end mount-jacks.
- Page 12 AG8 Callouts Battery cover - Pull back gently on this cover at the ribbing and pry upwards to remove. Battery compartment - Insert a standard AA (LR6) alkaline battery here, being sure to observe the plus and minus polarity markings shown. Although rechargeable Ni-Cad batteries can be used, they do not supply adequate current for more than four hours of operation.
- Page 13 CR88x Receiver Features - Front Panel Antennas - The antenna mountings allow full rotation for optimum placement. In normal operation, both antennas should be placed in a vertical position. Both antennas can be folded inward for convenience when transporting the CR88x. VOLUME Control - This knob sets the level of the audio signal being output through both the balanced and unbalanced output jacks on the rear panel.
- Page 14 CR88x Receiver Features - Rear Panel DC Input - Connect the supplied power adapter here, using the strain relief as shown in the illustration below. WARNING: Do not substitute any other kind of power adapter. Doing so can cause severe damage to the CR88x and will void your warranty. BALANCED OUTPUT - Use this electronically balanced low impedance (600 Ohm) XLR jack when connecting the CR88x to professional (+4dBu) audio equipment.
-
Page 15: Rack Mounting
Rack Mounting The CR88x receiver can be installed into a standard 19” rack for transport or permanent installation using the included rack ears. Follow the simple steps below to mount the CR88x: Attach the included rack ears by sliding each rack ear into the groove on either side of the CR88x until they lock into place, and the receiver flush with the front panel. -
Page 16: Troubleshooting
Troubleshooting Issue Solutions Make sure that the transmitter and receiver are both powered on. Ensure the AG8 transmitter’s batteries are fully charged. Check that the transmitter is not muted. Confirm that the CR88x adapter is correctly connected and plugged into an electrical outlet. Turn on the CR88x receiver. -
Page 17: Specifications
15 VDC 200mA Dimensions (LxWxH) 8.25" x 4.9" x 1.75" 210mm x 125mm x 44mm Weight 0.88lb / 400g At Samson, we are continually improving our products, therefore specifications and images are subject to change without notice. AirLine 88x Wireless System... - Page 18 ª Licensing: Note that a ministerial license to operate this equipment may be required in certain areas. Consult your national authority for possible requirements. Licensing of Samson wireless microphone equipment is the user’s responsibility, and licensability depends on the user’s...
- Page 20 Having Trouble with your AirLine Wireless System? We can help! CONTACT OUR SUPPORT TEAM: support@samsontech.com Our experts can help you resolve any issues. Follow us: @samson @samsontech @samson_technologies Samson Technologies 278-B Duffy Ave Hicksville, NY 11801 Phone: 1-800-3-SAMSON www.samsontech.com...