Tripp Lite SmartOnline SU1000RTXL2U Owner's Manual page 4

200608121 93-2609 SU Owner's Manual.qxd
Installation
Connection and Start-Up
Plug your UPS's line cord into an
1
electrical outlet.
If your model features a detachable line cord,
first plug the female end into your UPS's AC
Input Receptacle.
Your UPS must be connected to a dedicated
circuit of sufficient amperage—check the
"Recommended Utility Amps" rating of your
model in the specifications. Note, however, that
the select models may be fitted with different
plug types. Refer to the "OP Rating/Plug
Rating" chart printed on the top of your UPS.
Once your UPS is plugged in, the fan and all
Indicator Lights will turn ON. The "LINE" and
"LOAD ACTIVE
illuminate and the UPS will emit a beep to
indicate normal operation. However, power is
not supplied to your UPS's AC outlets until the
UPS is turned on.
2
Plug your equipment into your UPS.
Your UPS is designed to support computer
equipment only. You will overload your UPS if
you connect household appliances or laser
printers to the UPS's outlets.
3 Turn your UPS ON:
• Press the "ON/TEST" Switch
• Hold it for several seconds until you
hear a beep
• Release it
Your UPS will begin providing AC power to its outlets.
The "ON LINE" LED will illuminate.
(continued)
METER" LEDs will
4
10/3/2006 3:32 PM Page 4
SU2200RTXL2U Plug
(NEMA 5-20) shown
1
2
SU2200RTXL2U shown
3