Power - Clavia Nord Drum 2 User Manual

Trig Inputs CH 1 – CH 6
Connect drum pads or other signal sources
to the Trig Input ¼" jacks . These inputs can
be used with a variety of different signals . The
sensitivity and the threshold of the inputs can
be adjusted with the Inp Sens and Inp Thres
parameters, read more about this in the fol-
lowing chapter .
E Do not connect pads while the Nord Drum
2 is turned on, this will trigger the sounds.
The Nord Drum 2 has been developed and
tested with different pad and trigger types .
The Trig Inputs are designed to be very ver-
satile and is compatible with many different
types of signals .
M If you experience double triggered
sounds, flams or a slow response from
the Nord Drum 2, make sure that you ad-
just the Trig Type, Inp Thres and Inp Sens
parameters. Read more on how to adjust
these settings on page 9
Chapter 1 overview

Power

Connect the Nord Drum 2 power supply to
the Power input . If the original supply is not
available, use only a 12 volt DC, 250 mA
adapter, with a barrel type plug that has the
positive current on the tip . The outer diameter
of the plug is 5 .5 millimeter and the inner
diameter is 2 .1 millimeter .
E Always turn on the Nord Drum 2 first and
the sound system last, and reverse this
order when you want to turn it off again.
Nord Pad Input
Connect a Nord Pad to the RJ45 connector,
using the CAT6 cable that is supplied with the
Nord Pad .
E This connection can not be used with any
other equipment. Do not try and connect
a computer network or any other RJ45
equipped unit to the Nord Drum 2.
| 5