Table of Contents
Advertisement
3.1 Operation Mode
The VC-230 supports two operation modes – Router and Bridge and VC-230N supports
three operation modes – Router, Bridge and WISP. Currently, it comes pre-configured with
routing mode.
Note that, routing mode and bridging mode cannot be used simultaneously.
For Bridge mode, all interfaces are bridged into a single bridge interface.
For Router mode, the VDSL port is treated as WAN port. The other interfaces are bridged
together and are treated as LAN ports.
For WISP Mode, all the Ethernet ports (including VDSL2) are bridged together and the
wireless interface of this router will comes to WAN port for connecting to an ISP's Access
Point as Internet connection. The NAT is enabled and PCs in Ethernet ports share the
same IP to ISP through wireless LAN. The connection type can be setup in WAN page by
using PPPoE, DHCP client, PPTP/L2TP client or static IP.
If you select Bridge operation mode, WAN configuration in Internet Settings are not
available. (Firewall functions on the left page are not available, too.)
After finishing setting, click Apply to save the settings and make the new configuration take
effect. Click Cancel to close without saving.
33
Advertisement
Table of Contents
