50W @6 Ohm AA-AB34165 25W @6 Ohm They integrate ST’s high performance TDA7498 supporting dual channel audio amplification. Both of channels are capable of outputting nominal power simultaneously and continuously. They integrate an external extensible interface to connect the matching product of a volume control board and a rotary encoder board for volume control.
Class D Audio Amplifier Board - TDA7498 FIGURE 1-2 ACCESSORIES PACKAGE (OPTIONAL) Note: The diagrams above are used for reference only. 1.2 Features A perfect "Class D" architecture Frequency response: 20Hz to 20KHz(±3dB) Four selectable, fixed gain settings of nominally 25.6 dB, 31.6 dB, 35.1 dB and 37.6...
Class D Audio Amplifier Board - TDA7498 FIGURE 2-2 INPUT CONNECTION TABLE 2-2 INPUT CONNECTION Connector Mark Channel Description Channel 1 Input RCA connector Channel 2 Input Channel 1 Input Terminal Blocks (Optional) Channel 2 Input Note: You are allowed to feed only one group (dual channel) of audio signal to the amplifier board at a time.
Class D Audio Amplifier Board - TDA7498 supply voltage once the input signal reaches the peak. Take AA-AB32189 for example, the maximum amplitude of the input signal is no more than 320mV RMS when power supply voltage is 36V, load impedance is 6 ohm and the gain is set at 37.6 dB.
CLASS D AUDIO AMPLIFIER BOARD - TDA7498 USER’S GUIDE Chapter 3. Electrical Characteristics Following table lists all typical data of the Amp board. For full specification, please refer to the data sheet of ST’s TDA7498 chip. TABLE 3-1 ELECTRICAL CHARACTERISTICS Parameter Condition Min.
Page 13
Class D Audio Amplifier Board - TDA7498 Storage Temperature -20℃ 20℃ 105℃ Thermal Shutdown 150℃ Note: 1. Stresses beyond the listed maximum power supply voltage may cause the permanent damage to components on board. The input sensitivity values are calculated on the basis of 6 Ohm load.