Table of Contents
Advertisement
Using the Tool
Vehicle Selection
Selecting a vehicle is required to communicate with the vehicle and to correctly
display DTC definitions. The Tool keeps all data received from the last vehicle
selected until a new vehicle is selected or the Tool is reprogrammed to update
software.
During vehicle selection, the Tool may ask for the following information:
❒
Manufacturer
❒
Car/Truck
3
❒
Year
❒
Make
❒
Model
❒
Engine
❒
Special Information
From the Main Menu:
1. Choose Vehicle Diagnostics.
• Press the
• Press ENTER.
2. Select to KEEP or CHANGE
vehicle.
• To run or review diagnostics on
• To run diagnostics on a different
• If this is the first time that you are
✓
The vehicle identification information is
used by the Tool to perform diagnos-
tics. Enter or confirm vehicle identifica-
tion information.
3 – 12 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
UP or
key until Vehicle Diagnostics is
highlighted
the same vehicle, press
for YES. Continue these instruc-
tions with Step 3.
vehicle, press
RIGHT for NO.
Continue these instructions with
Step 4.
using the tool or no vehicle identi-
fication information is stored in
memory, the Tool will ask you to
provide vehicle identification infor-
mation. Go to Step 5 below to
continue.
DOWN arrow
=====================
Vehicle Diagnostics
Review Codes
System Setup
LEFT
MAIN MENU
Confirm Selection
2002 Sunfire
2.2L
Manual Transmission
Ke ep This Vehicle?
YES
NO
Advertisement
Table of Contents
