Table of Contents
Advertisement
SW45-T Beltpack Transmitter
B1
B2
B3
B4
B5
B6
B7
B8
Sabine SWM4000 Smart Spectrum
Controls
Antenna (replaceable)
B1
Audio gain adjustment switch
B2
IR port - Receives infrared beam to synchronize frequencies.
B3
When using multiple systems, only one transmitter IR port should be exposed at a time.
LCD screen
B4
Battery cover (slide both clips down to open)
B5
TA4-F microphone input jack
B6
On-off switch
B7
On-off / on-mute / on-on switch (located under the case, above the battery compartment).
B8
Use a pencil to select option. Switch is hidden to protect from accidental nudge.
Up
B9
Down
B10
Select
B11
Wearing the Beltpack Transmitter
Clip the transmitter to a belt until the belt is pressed
against the base of the clip.
Changing Batteries
Expected life for an Alkaline battery is approximately 8 hours.
Change batteries when the battery bar in LCD display is empty, as shown below:
B9
B10
B11
Programming the Beltpack Transmitter
1. With the power on, press and hold the select button until the GROUP and CHANNEL
displays begin to alternate.
2. To change the group setting, release the select button while GROUP is flashing.
(While GROUP is flashing, pressing up or down increases/decreases the group setting by one.)
3. Press select button to switch between GROUP and CHANNEL settings.
Indicates charge remaining in transmitter batteries.
Wireless
®
Top view
B1
B7
B2
8
B6
Advertisement
Table of Contents
