Table of Contents
Advertisement
Appendix E
Specifications
SW40 Receiver
Operating Range Under Typical Conditions: 100m (300 ft)
(actual range depends on RF signal absorption, reflection, and interference)
Audio Frequency Response (+/- 2 dB)
Maximum: 20 kHz / Minimum: 50 Hz
(Overall system frequency depends on microphone element.)
Total Harmonic Distortion (ref. +/- 30 kHz deviation, 400Hz tone)
0.5%, typical
Dynamic Range: >100 dB A-weighted
Operating Temperature Range: -18ºC (0~F) to +57ºC (+135ºF)
Note: battery characteristics may limit this range
Dimensions:
SW40-R4: 44 mm H x 420 mm W x 207 mm D
SW40-RH: 41 mm H x 205 mm W x 158 mm D
Weight: 960 g
Housing: Galvanized steel
Audio Output Level(ref.+/- 30kHz deviation with 400Hz tone)
XLR connector (into 600 Q load): -30dBV
1/4 inch connector (into 3000 Q Ioad):-9dBV
Output Impedance
XLR connector: 200 / 1/4 inch connector: 1k
XLR output: Impedance balanced
Pin 1: Ground (cable shield)
Pin 2: Audio
Pin 3: No Audio
Sensitivity: -105 dBm for 12 dB SINAD, typical
Image Rejection: >70 dB, typical
Power Requirements: 22V dc at 400mA, supplied by external PSU
SW40-H Handheld Transmitter
RF Transmitter Output: 30 mW maximum
(dependent on applicable country regulations)
Dimensions (including EM-l1S cartridge): 270 mm x 52 mm dia.
Weight: 250 g without batteries
Housing: Metal case with handeling-noise suppression and soft touch,
non slip finish
Power Requirements: 2 "AA" size alkaline or rechargeable batteries
Battery Life: >8 hours (alkaline)
SW45-T Beltpack Transmitter
Gain Adjustment Range: 30 dB
Input Impedance: 500 K
RF Transmitter Output: 30 mW maximum
(dependent on applicable country regulations)
Dimensions: 97 mm H x 66 mm W x 20 min D
Weight: 105 g without batteries
Housing: Molded ABS case
Power Requirements: 2"AA' size alkaline or rechargeable batteries
Battery Life: >8 hours (alkaline)
Sabine SWM4000 Smart Spectrum
14
Wireless
®
Appendix F
Frequency Allocation Chart
Advertisement
Table of Contents
