Cleaning; Operating Instructions - Bushranger 46TBU6 Owner's Manual

OPERATING INSTRUCTIONS

Starting & Stopping
4 Stroke Engine - Briggs & stratton, See engine manual & procedure below.
STARTING COLD
1. Move the throttle control lever to the choke/start position.
Starting hot: Use the RUN position if the Engine is warm
Note: If engine does not have a choke. Move the throttle lever
to the START position & primer 3 times slowly
COLD START: press the primer bulb three times pausing each
time.
HOT START: priming may only be necessary if the mower fails
to start.
2. Pull the starter grip lightly until resistances felt, then pull
briskly.
3. When the engine warms up, move the throttle to the RUN
position.
STOPPING THE ENGINE
Move the throttle control lever to the stop position.

Cleaning

• Remove grass build up from the air intakes on the top of the mower cowl, around the
engine and carburettor, and around the air filter body.
• The underside of the mower should be cleaned regularly to remove dirt and grass build
up, any build up will adversely affect corrosion of steel baseplate.
6
CAUTION!
Do not allow the starter grip to snap back against the
engine. Return it gently to prevent damage to the starter.
Before cleaning the mower, ensure
the throttle lever is in the 'STOP'
position. Turn the fuel tap off,
disconnect the spark plug lead and
wedge it between the cylinder fins.
S T A R T I N G
I
COLD HOT
CHOKE CHOKE
CHOKE CHOKE
R U N R U N
R U N R U N
STOP
STOP
CHOKE CHOKE
R U N R U N
STOP
CHOKE CHOKE
R U N R U N
STOP
Spark
Plug