Wegener DTV701 User Manual page 34

7. When the terminal indicates that the file transfer is complete, type
8. If the current application is not the desired one, use the SWITCH com-
9. Type RESET to restart the unit.
10. As the unit restarts, verify from the front panel (should display as shown
800015-01 Rev. D
XMODEM 1K protocol may be used.) The following will appear on the
front-panel LCD:
DOWNLOADING:
APP CODE (FLASH x)
Where x is either A or B, representing the two possible application code
storage spaces in the Flash memory.
"APPSTAT" to verify that the application loaded correctly. (This takes
approximately four minutes to complete.) An asterisk is shown beside the
current application (A or B).
mand to make another application the current one. Type "SWITCH A" to
switch to application A or "SWITCH B" to change to application B.
below) that the desired application is being initiated.
Loading Application
NNN
34
DTV 701 User's Manual
wegener.com