Table of Contents
Advertisement
3.1 Operation Overview
This chapter contains detailed operating instructions for your DTV701. The
following sections address:
Local user control is from a LAN via RJ-45 Ethernet or the front-panel LCD/
keypad. All settings may be presumed to be retained through power cycling
unless otherwise specified. This means that they are still in effect through
resets, whether by power outage, commanded reset, or failure-recovery resets.
3.2 Ethernet/Web Browser Control
The DTV701's primary user interface is from a web browser using the rear-
panel Ethernet LAN connection. An HTML script interface allows a user to
control and monitor the unit using a standard web browser. Each unit contains
a user-defined quad URL address, subnet mask, and gateway address (See
DTV701 IP Setup).
There are two basic methods of using the Ethernet connection – with a directly
connected PC or with a PC connected through a LAN.
Directly
For control from a local PC, attach the DTV701's Ethernet port to the Ethernet
connected PC
network connector on the PC using a crossover RJ-45 cable (8 pins).
Before using this Ethernet connection, the appropriate IP address, netmask,
and gateway must be selected via the front-panel interface.
wegener.com
Chapter 3 Operation
• Ethernet/Web Browser Control
• DTV701 Controls and Indicators
• Front-panel Operation
• Initialization
• Transport Stream Processing
• Alarm/Warning System
• Software Downloads
19
800015-01 Rev. D
Advertisement
Table of Contents
