Table of Contents
Advertisement
DTV 701 User's Manual
Before applying power, make the following connections to your DTV701
(refer to Table 3 for connector details):
Designation
Connector Type
115/230 Vac Power
Male IEC receptacle
RF Input
female Type F
ASI Out 1
female BNC
ASI Out 2
female BNC
wegener.com
Figure 2.2 DTV701 Rear Panel
a) Connect the chassis grounding screw to an earth ground before
connecting the power cord to the unit.
b) Connect the ATSC 8VSB signal from your antenna to the DTV701's
input RF port.
c) Connect downstream equipment to the ASI OUT 1 and ASI OUT 2
ports as desired.
d) Connect your LAN line to the DTV701's Ethernet port.
e) If desired, connect the Relays port to your equipment to provide contact
closures during alarms and warnings.
f) Finally, connect the supplied ac power cord to the DTV701's IEC
receptacle and to a 100-to-120 Vac source.
Table 3: DTV701 Connector Details
Number
Pin
AC LINE IN
RF IN
ASI OUT 1
ASI OUT 2
17
Signal Name
800015-01 Rev. D
Advertisement
Table of Contents
