Line And Load Connectors - ETC Sensor User Manual

Sensor Portable Pack User Manual

Line and load connectors

The back panel of the Sensor Portable Pack contains both line
and load connectors.
Load connectors
The Sensor Portable Pack may be configured with either stage
pin; grounded twistlock; parallel blade; or multi-pin connectors
(Veam, Socapex or Pyle) to connect the pack to lights or other
output devices.
Line feed connectors
The back panel contains Cam-Lok
connectors. Line feed cables with mating connectors (not
supplied) must be connected to the Cam-Lok power connec-
tors in the order described below. To connect the Cam-Lok
connector, insert it into the back of the pack, then twist
clockwise until it locks in place. Reverse this procedure to
disconnect the cables.
Connect cables in this order:
1. Grounding plug (Green)
2. Neutral plug (White)
3. Phase plugs (Black/Red/Blue)
Warning: Cables must be disconnected in the reverse
sequence!
Warning: Multiple power leads may be attached to the
Portable Pack. Disconnect all power leads before servicing or
attempting to work on any part of this device. Service connec-
tors must be installed and removed by qualified personnel
only.
E1016 series line feed
®
7