Ac Power Cable Connection; Switching On For The First Time; Remote On - Off - Viola Systems LEGACY Owner's Manual

For more information about the VIOLA Quartet or Duet please visit the VIOLA web
site at www.violalabs.com.

AC POWER CABLE CONNECTION

If the wall outlet you plan to use for the Legacy has an on/off switch, check that it is
switched off.
Insert the supplied AC mains cord into the receptacle on the rear of the Legacy and
ensure that it is pushed securely home.
Insert the other end of the mains cable securely into the mains outlet. Take care to
arrange the cable so that it is not bent sharply and that its weight will not pull it out
of either the mains outlet, or the receptacle on the rear of the Legacy.
Do not switch the unit on yet.

SWITCHING ON FOR THE FIRST TIME

Check that all the signal cables in the system are correctly connected.
Select the appropriate input on the pre-amplifier and set the volume to minimum.
Switch on the pre-amplifier and your signal source, which we will assume is a CD
player.
Allow the system to stabilize for 2 minutes, and then put a CD into the player and
press play.
If the wall outlet you are using for the Legacy is switchable, switch it on now.
The LED will be a dim green. This tells you the Legacy has AC power and is in
standby mode. The Legacy consumes less than a ½ Watt in standby.
Press the power switch on the Legacy's front panel. When the unit starts, the LED
will increase in brightness.
Allow the unit to stabilize for 2 minutes, and then slowly increase the volume on the
pre-amplifier to a comfortable level. The unit is now ready for use.
If you experience any problems, please refer to the trouble shooting section of this
manual.

REMOTE ON - OFF

The Legacy can be remotely turned off and on by a +12 Volt DC signal feed into the
remote in jack on the back of the Legacy. You can turn on multiple Legacy amplifiers
Viola Legacy Manual Rev 0
Page 8 of 14
14 th February 2009