Door Reversibility - Electrolux EN3881AOW User Manual

20 www.electrolux.com
• Connect the cable to the socket in the
front panel. (8)
• Put back the top front covers on both
sides (5,9).
• Place the display cable, which is cur-
rently disconnected, into the cable
holder in the door end cap then put
back the door end cap cover (10)
• Remove the covers (A). Remove the
cover plugs (C).
• Unscrew the handles (B)and fix them on
the opposite side. Place the upper han-
dle to the lower door and the lower
handle to the upper door
7
6
10
9
8
• Re-insert the cover plugs (C) on the op-
posite side.
C
C
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabi-
net.
• The door opens and closes correctly.
WARNING!
In case you do not want to carry
out the above mentioned opera-
tions, contact the nearest After
Sales Service Force. The After
Sales Service specialist will carry
out the reversibility of the doors at
your cost.
WARNING!
After having reversed the opening
direction of the doors check that
all the screws are properly tight-
ened and that the magnetic seal
adheres to the cabinet.
If the ambient temperature is cold
(i.e. in Winter), the gasket may not
fit perfectly to the cabinet. In that
case, wait for the natural fitting of
the gasket. Lay down the appli-
ance back side down.

8.8 Door reversibility

WARNING!
Before carrying out any opera-
tions, remove the plug from the
power socket.
B
A
A
B