Electrical Connection - Electrolux EN3881AOW User Manual

18 www.electrolux.com
8.4 Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front.
8.5 Installation of the
TasteGuard filter
The TasteGuard filter is an active carbon
filter which absorbs bad odours and per-
mits to maintain the best flavour and aro-
ma for all foodstuffs without risk of odour
cross contamination.
On delivery the carbon filter is in a plastic
bag to maintain it's duration and charac-
teristics. The filter should be placed be-
hind the flap before the appliance is
turned on.
1. Open the flap cover.
2. Remove the filter from the plastic bag.
3. Insert the filter in the slot found in the
back of the flap cover.
4.
Close the flap cover.
The filter should be handled care-
fully so fragments do not loosen
from the surface. The filter should
change once every six months.
To get the best performance the
carbon air filter should be
changed once every six months.
New active air filters can be pur-
chased from your local dealer.

8.6 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
contact for this purpose. If the domestic
power supply socket is not earthed, con-
nect the appliance to a separate earth in
compliance with current regulations, con-
sulting a qualified electrician.
The manufacturer declines all responsibili-
ty if the above safety precautions are not
observed.
This appliance complies with the E.E.C.
Directives.
8.7 Door reversibility
WARNING!
Before carrying out any opera-
tions, remove the plug from the
power socket.
WARNING!
Make sure that the appliance is
electrically not powered.
To carry out the following opera-
tions, we suggest that this be
done with another person who will
keep a firm hold on the doors of
the appliance during the opera-
tions.
• Remove the upper hinge cover with a
screwdriver (4).
• Open the door and remove the door
end cap cover (1) .
• Remove the top front covers on both
sides. (2,6).
• Unplug the cable connector of the dis-
play (3).