Installation - Electrolux EN3881AOW User Manual

7.2 Closing the door
1. Clean the door gaskets.
2.
If necessary, adjust the door. Refer to

"Installation".

8. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
SN
N
ST
T
8.2 Location
The appliance should be installed well
away from sources of heat such as radia-
tors, boilers, direct sunlight etc. Ensure
that air can circulate freely around the
back of the cabinet. To ensure best per-
formance, if the appliance is positioned
below an overhanging wall unit, the mini-
mum distance between the top of the
cabinet and the wall unit must be at least
100 mm . Ideally, however, the appliance
should not be positioned below overhang-
ing wall units. Accurate levelling is ensur-
ed by one or more adjustable feet at the
base of the cabinet.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
A
WARNING!
It must be possible to disconnect
the appliance from the mains
power supply; the plug must
therefore be easily accessible after
installation.
8.3 Rear spacers
You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1. Release the screw.
2.
Engage the spacer below the screw.
3. Turn the spacer to the right position.
4.
Tighten again the screws.
4
ENGLISH 17
B
2
1
3