Making A Phone Call - West Marine 14286801 Owner's Manual

®
BLUETOOTH OPERATION
Manual Dialing
using IR remote control
Placing a call from the
Recent Calls List
Redialing the last
number
Receiving a Phone Call
Ending a Phone Call

Making a Phone Call

• Press
appear on the display.
• Using the remote control, enter the phone number using
the 0-9 buttons. Press
WM4000 front panel to begin dialing.
Placing a phone call from your cell phone will also use the Bluetooth
phone
function of the WM4000.
• Press SELECT from Bluetooth mode to view the 10 most
recent phone calls that were dialed, received or missed
while connected to the WM4000.
• Turn the volume knob to cycle through the recent phone
numbers. Press SELECT or
To redial the last phone number, press
mode. Dialing will begin automatically.
Receiving and Ending Phone Calls
Incoming phone calls will automatically appear on the display and a
ring tone will be heard.
Note: The volume of the ring tone depends on the volume level of the
WM4000. The incoming ring tone may not be heard if the volume is
set to a low level or mute is activated.
• Press
• Press and hold
call.
Note: If Auto Answer is set to ON in the setup menu, all phone calls
will be received automatically after a few rings.
During an active phone call, press
phone call was received when listening to music in another mode, the
WM4000 will resume the previous mode.
WM4000
once. "ENTERNUM" will be shown, then an "_" will
on the remote control or
to dial the phone number.
to receive the incoming phone call.
for 3 seconds to refuse the incoming phone
23 1-800-BOATING
three times from Bluetooth
to end a phone call. If the