Bluetooth Operation; Pairing A Device; Disconnecting A Device - West Marine 14286801 Owner's Manual

®
BLUETOOTH OPERATION
Preparation
Pairing a New Device
Pairing Additional
Devices
Many Bluetooth devices support the auto-connect feature, and will connect automatically if the device
is in range when the WM4000 is powered-on. If your device was previously paired but does not
connect, use these instructions below. Some devices require authorization to allow the auto connect
feature.
Reconnect the last device:
• If your most recently connected Bluetooth device becomes disconnected or does not reconnect,
simply press once from Bluetooth mode to reconnect your mobile device.
Reconnect a previously paired device:
• To connect a previously paired device that was not recently connected:
1. If applicable, press and hold
2. From Bluetooth mode, press SELECT. "Paired List" will appear on the display.
3. Turn the volume knob to cycle through the list of devices.
4. Press SELECT or
Note: If the Auto Connect setup menu setting is set to OFF, you must press
device after pairing, and each time the WM4000 is powered-on.
Press and hold for 3 seconds to disconnect a connected device. The device will remain paired and
appear in the PAIRED DEVICES menu, but will not be connected.

Pairing a Device

Before you can use a Bluetooth device, it must be paired and
connected. Make sure that Bluetooth is activated on your device
before you begin the pairing process.
The WM4000 broadcasts the pairing signal constantly when no
devices are currently connected. Complete the pairing sequence from
your Bluetooth device. Refer to the owner's manual for your device for
more details.
The device name is "WM4000"
The Bluetooth passcode "1234"
Note: The WM4000 can be in any mode when you can pair a
phone.
If a device is currently connected, press and hold
the current device before a new device can be paired. Then begin the
pairing sequence from the new Bluetooth device.
(Re)Connecting a Paired Device
to disconnect any connected mobile devices.
to connect to the desired device. It must be in range to connect.

Disconnecting a Device

WM4000 22 1-800-BOATING
to disconnect
to connect you