Fitting And Removal Of Base - Iiyama ProLite XB2780HSU User Manual

FITTING AND REMOVAL OF BASE

The monitor is supplied complete with a stand. If you prefer to wall mount the monitor, please follow
the instructions below to remove the stand. Be sure to include the stand with the monitor if it is
necessary to return the unit.
 Put the monitor on a stable surface. The monitor may cause injury or damage if it
CAUTION
falls or is dropped.
 Do not give a strong impact to the monitor. It may cause damage.
 Unplug the monitor before removal or installation to avoid electric shock or damage.
<Installation>
Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. Lay
the monitor fl at on a table with front face down.
Install the Stand-Base to the Monitor.
Fix the Monitor to the Stand by both screws fi rmly and then push-down knob.
<Remove>
Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. Lay
the monitor fl at on a table with front face down.
Pull up the knob, then remove the screws and the Stand-Base.
<Stopper pin>
Please stand the monitor and then remove the stopper
pin on the back of the stand slowly while pushing top
face of the stand before you install the monitor. Careful
attention is required as the monitor is sprung loaded and
may expand quickly when removing it.
6 BEFORE YOU OPERATE THE MONITOR
Push-down knob
Screws for Stand-Base fi xing
Stand-Base
Stopper pin