Using Subwoofer Output - Pioneer DEH-P800PRS Operation Manual

Audio Adjustments
5 Push MULTI-CONTROL up or down to
adjust the level of the selected speaker
unit (filter).
Each time MULTI-CONTROL is pushed up or
down, the level of the selected speaker unit (fil-
ter) increases or decreases.
±0dB to –24dB is displayed as the level is in-
creased or decreased.
+6dB to –24dB is displayed as the level is in-
creased or decreased, only if you have se-
lected Low LPF.
6 Turn MULTI-CONTROL to select NW 3.
NW 3 appears in the display.
7 Push MULTI-CONTROL left or right to
select the slope of the selected speaker
unit (filter).
Each time MULTI-CONTROL is pushed left or
right, slopes are selected in the following
order:
Low LPF: –36— –30— –24— –18— –12 (dB/
oct.)
Mid HPF: –24— –18— –12— –6—Pass (0)
(dB/oct.)
Mid LPF: –24— –18— –12— –6—Pass (0)
(dB/oct.)
HighHPF: –24— –18— –12— –6 (dB/oct.)
8 Push MULTI-CONTROL up or down to
switch the phase of the selected speaker
unit (filter).
Push MULTI-CONTROL up selects normal
phase and NOR appears in the display. Push
MULTI-CONTROL down selects reverse phase
and REV appears in the display.
# You can adjust the parameters for other
speaker units (filters) in the same way.
9 Turn MULTI-CONTROL to select NW 4.
NW 4 appears in the display.
10 Push MULTI-CONTROL left or right to
select stereo or monaural.
Push MULTI-CONTROL left to select monaural
and MONO appears in the display. Push
MULTI-CONTROL right to select stereo and
Stereo appears in the display.
# You can operate this procedure only when
Low LPF is selected.
11 Press BAND to cancel the network ad-
justment mode.

Using subwoofer output

Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off. When a sub-
woofer is connected to this unit, turn the sub-
woofer output on.
The subwoofer output phase can be switched
between normal and reverse.
1 Use MULTI-CONTROL to select SW 1.
SW 1 appears in the display.
2 Press MULTI-CONTROL to turn subwoo-
fer output on.
ON appears in the display. Subwoofer output
is now on.
# To turn subwoofer output off, press
MULTI-CONTROL again.
3 Push MULTI-CONTROL left or right to
select stereo or monaural.
Push MULTI-CONTROL left to select monaural
and MONO appears in the display. Push
MULTI-CONTROL right to select stereo and
Stereo appears in the display.
Section
13
61
En