Switching the DSP setting mode
This product features two operation modes: the 3-way network mode (NW) and the standard mode (STD).
You can switch between modes as desired. Initially, the DSP setting is set to the standard mode (STD).
•
After switching, reset the microprocessor. (Refer to operation manual.)
• Use a thin standard tip screwdriver to switch the DSP switch on the side of this
product (Fig. 15).
Fixing the front panel
If you do not operate the removing and attaching the front panel function, use the supplied fixing screw and
fix the front panel to this unit (Fig. 16).
Fixing screw
<ENGLISH>
Fig. 15
Fig. 16