Kenmore 415.16505900 Use And Care Manual page 18

Burner and Firebox and Control Knobs
11
Place burner assembly into firebox. Fasten the burner assembly to the firebox using 5x15 fiber washers and #10-24x1/2''
machine screws (A) .
Inside firebox, insert heat diffuser supports with 5x15 fiber washers to firebox through sides of firebox, then secure with
#10-24 flange nuts on outside of firebox (A).
Place firebox on cart. Make sure burner tubes are correctly engaged with valves. If burner is not level from left to right,
adjust the two screws attaching valve to control panel. Attach ignitor wire to ignitor ( B ).
Attach firebox with #10-24x1/2'' machine screws, 5x15 fiber washers and #10-24 flange nuts ( C ) .
Push control knobs onto valve stems ( C ).
Burner assembly
Firebox
A
#10-24 5x15
Fiber Washer
Flange Nut
Qty.10
Qty. 8
#10-24X1/2" Heat diffuser Support
Machine Screw Qty.4
Qty.6
Heat diffuser
support
B
Burner tube
Heat shield
for Tank
Valve
C
Make sure the burner tubes are located
underneath Heat Shield
Control Knob
Correct burner-to-valve engagement
Burner Tube
Valve
18 • 464722309 • 464722509