Kenmore 415.16505900 Use And Care Manual page 16

Control Panel and Firebox Support
7
Stand cart upright.
In front, fit control panel between left and right legs. Insert #10-24x2'' machine screws to hold panel in place. Place upper
firebox supports onto screws making sure angle side is facing the front and attach with # 10-24 flange nuts. See the insert
for correct placement.
In back, attach upper firebox support with #10-24x2'' machine screws and # 10-24 flange nuts.
NOTE:
Angle Edge
#10-24x2"
#10-24
Machine Screw
Flange Nut
Qty.8
Qty. 8
Valve/Hose/Regulator and Ignitor
8
Attach valve/hose/regulator assembly to control panel using #10-24x1/2'' machine screws.
Remove ignitor cap and plastic hex nut from Electronic Ignition Module assembly. Insert module into the opening on
control panel and attach with the removed hex nut. Place AAA battery into module slot with positive end (+) facing
outward. Screw ignitor cap onto module.
10
#10-24x1/2"
Valve/ Hose/ Regulator
Machine Screw
Assembly
Qty.2
16 • 464722309 • 464722509
Control panel
#10-24x1/2"
Machine Screw
Electronic Ignition Module
Right firebox
support
Button
AAA Battery
Hex Nut
#10-24x2"
Machine Screw
Left firebox
support