Yaesu VX-8GR Operating Manual page 40

CTCSS/DCS/EPCS O
CTCSS/DCS/EPCS B
P
Three User Beep Memories are provided, allowing you to create unique original beep
tone melodies.
Each User Beep Memory can store up to 64 steps with three octaves ("C1" through "B3").
1. Press and hold the
2. Rotate the DIAL knob to select Set Mode Item 10: BEEP
MELODY.
3. Press the
Mode Item.
4. Rotate the DIAL knob to select the memory slot into which
you wish to store your programmed beep melody. Avail-
able selections are 1, 2, and 3. The previously stored beep
melody will be displayed.
5. Press the
Press and hold the
previous beep melody, if desired.
6. Rotate the DIAL knob to select the first beep tone of the
User Beep Melody. Available selections are C1 - B3, and
POS (rest).
7. Press the
length of the first beep tone. Available selections are 10ms
(10 msec) - 2500ms (2.5 sec).
8. Press the
Beep Melody.
9. If you make a mistake, press the
the cursor, then re-enter the correct beep tone or length.
10. Repeat steps 6 - 9 until you have completed the User Beep
Melody.
11. When there is a beep tone, which you wish to delete, bring
the cursor to that beep tone using the
press the key repeatedly until the "SELECT" notation
in the "Operation Mode" slot turns into "DELETE". Now,
press and hold in the
C1 D1 E1 F1
38
U M
key for one second to enter the Set Mode.
key briefly to enable adjustment of this Set
key to enable programming the beep melody.
key for one second to clear any
key, then rotate the DIAL knob to set the
key to accept the first beep tone of the User
key for one second to delete that beep tone.
G1 A1 B1 C2 D2
O
key to back-space
/ key, then
E2 F2 G2 A2 B2
VX-8GR O
Step Operation Mode
Beep Tone
Memory Slot Tone Length
C3 D3 E3 F3 G3
M
A3 B3