Cw Learning Feature - Yaesu VX-8GR Operating Manual

CW L
EARNING
The VX-8GR provides a CW learning feature, which sends the designated Morse Code
via the sidetone (heard in the speaker) to help your CW learning.
1. Press and hold the
2. Rotate the DIAL knob to select Set Mode Item 17: CW
LEARNING.
3. Press the
Mode Item.
4. Rotate the DIAL knob to select the Training mode (displayed
in fine print at the upper edge of the LCD):
ALPHA:
ALPHA AUTO:
NUMBER:
NUMBER AUTO: Sends the Numeric characters (move to next character automatically)
SYMBL:
SYMBL AUTO:
5. Press the
tate the DIAL knob to select the CW code which you want
to learn.
6. Press the
rotate the DIAL knob to select the Morse speed. You may
select the units of the code speed in either "CPM (charac-
ters per minute)" or "WPM (Words per minute)" using the
DIAL knob from Set Item "FORM".
7. Press the
rotate the DIAL knob to select the sending repetition (1 -
9).
8. Press the
rotate the DIAL knob to adjust the CW sidetone pitch (400
- 1000 Hz, 50 Hz/step).
9. Press the
tate the DIAL knob to switch the flashing of the (white)
LED light "on" and "off".
10. Press the
characters the designated number of times (Only the speaker
CW sidetone is heard, the radio does not transmit).
11. You may adjust the CW sidetone audio level by rotating the DIAL knob while press-
ing and holding the
12. If one of the "AUTO" modes is not selected in step 4 above, press the
again, or select another code by rotating the DIAL knob from "CHR" item and press
104
F
EATURE
key for one second to enter the Set Mode.
key briefly to enable adjustment of this Set
Sends the Alphabet characters
Sends the Alphabet characters (move to
next character automatically)
Sends the Numeric characters
Sends the Symbol characters
Sends the Symbol characters (move to next character automatically)
key to change the cursor to "CHR", then ro-
key to change the cursor to "SPED", then
key to change the cursor to "REPT", then
key to change the cursor to "PTCH", then
key to change the cursor to "LED", then ro-
key to begin generating the selected code
key.
VX-8GR O
key to send
M