Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for moon CD 3.3
Summary of Contents for moon CD 3.3
- Page 1 Owner’s Manual MOON CD 3.3 CD Player...
-
Page 2: Important Safety Instructions
MOON CD 3.3 CD Player Important Safety Instructions Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block ventilation openings. Install in accordance with the manufacturer’s instructions. - Page 3 NEVER wet the inside of the MOON CD 3.3 with any liquid. If a liquid substance does enter your CD 3.3, immediately disconnect it from the AC mains and take it to your MOON dealer for a complete check-up.
-
Page 4: Table Of Contents
MOON CD 3.3 CD Player Table of Contents Congratulations ..........5 Unpacking and Warnings ........5 Introduction ............ 6 Installation & Placement ........6 Front Panel Controls ......... 7 Rear Panel Connections ........9 SimLink™ ............10 Operating the CD 3.3 ........10 Remote Control Operation ........11... -
Page 5: Congratulations
MOON CD Players are so musically satisfying. The performance of your CD 3.3 will continue to improve during the first 400 hours of listening. This is the result of a “break- in”... -
Page 6: Introduction
You should avoid placing it near a heat source or inside a closed cabinet that is not well ventilated as this could compromise the CD Player’s performance and reliability. The CD 3.3 uses a toroidal transformer; even though it is well shielded, you should not place the player too close to source components sensitive to EMI, such as turntables and phono You should never place another component directly on top of this CD Player. -
Page 7: Front Panel Controls
When a CD is first loaded into the CD 3.3, the total number of tracks, and total playing time will appear in the display. In the event that you load a CD that contains no musical tracks (i.e. data only), the word ‘DATA’ will appear in the display window. - Page 8 When you select a digital signal from an external source, the display window will show “D1” followed by four dashes as follows “----” which indicates that the CD 3.3 is in the process of locking onto the external digital signal – this may take several seconds.
-
Page 9: Rear Panel Connections
In the event that you have purchased your MOON CD 3.3 with optional balanced analog circuitry, there will be a pair of XLR balanced outputs located to the right of the RCA analog outputs. In this case, we strongly recommend that you use the balanced XLR connectors on your CD 3.3 to maximize its level of performance:... -
Page 10: Simlink
‘CD’. A second feature of SimLink™ involves the “Standby” function. By pressing down and holding the “Standby” button for 2 seconds on the either the CD 3.3 or i 3.3, both units will go into “Standby” mode. The same logic applies when switching from “Standby”... -
Page 11: Remote Control Operation
To engage the CRM remote for use with the MOON CD 3.3 CD Player, you must first press the button labeled CD. -
Page 12: Specifications
Balanced Pin Assignment: Pin 1........ Ground Pin 2........ Positive Pin 3 ......Negative NOTE: In the event that you require the RS-232 codes for your MOON CD 3.3, please contact Simaudio Ltd. directly by either email (service@simaudio.com) or by toll-free telephone (877-980-2400). Fuse Replacement: For the 120V version use a 0.2A slow blow (5 x 20mm size).
Need help?
Do you have a question about the CD 3.3 and is the answer not in the manual?
Questions and answers