Foot Platform Height Adjustment; Foot Platform Depth Adjustment; Quick Release Fastener Operation; Underside Of Foot Platform - Quantum 6000 Owner's Manual

Hide thumbs Also See for 6000:
Table of Contents

Advertisement

V .
C O M F O R T
NOTE: For contour seats, loosen the setscrew on the
underside of both armrests, transfer the controller, and
tighten the setscrews. See figure 19.
7. Route the controller cable to the back of the power
base and plug in the controller. See figures 12 and 13.
8. Replace the rear shroud and tighten the fasteners.
9. Secure the controller cable to the armrest with wire ties.
See figure 13.

Foot Platform Height Adjustment

The foot platform height is easily adjusted to different heights
in 1/2-in. increments.
To raise or lower the foot platform:
1. Remove the quick release fasteners from the foot plat-
form bracket. See figure 20.
2. Raise or lower the foot platform to the desired height.
3. Reinstall the quick release fasteners into the foot plat-
form bracket and tighten.

Foot Platform Depth Adjustment

To adjust the foot platform depth:
1. Remove the quick release fasteners from the foot plat-
form bracket. See figure 20.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the quick release fasteners into the foot plat-
form bracket and tighten.
Quick Release Fasteners: The foot platform is attached
to the power base with two quick release fasteners. See
figure 20. Each quick release fastener consists of a bolt, a
lever, and a nut. See figure 21. The lever has a cam on the
end that allows it to clamp into place. The quick release fas-
tener has two states: clamped and unclamped. When the
lever is open, the quick release fastener is unclamped. When
the lever is closed, the quick release fastener is clamped
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-quar-
ter or one-half turn.
Quantum 6000
A D J U S T M E N T S
FOOT
PLATFORM
BRACKET
Figure 20. Foot Platform Adjustment
Figure 21. Quick Release Fastener Operation
Figure 22. Underside of Foot Platform
www.quantumrehab.com
QUICK RELEASE
FASTENERS
NUT
BOLT
UNCLAMPED
LEVER (OPEN)
SETSCREW
NUT
LEVER (FULLY
CLOSED)
CAM
CLAMPED
27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents