Armrest Width Adjustment; Armrest Height Adjustment; Armrest Angle Adjustment; Controller Position - Quantum 6000 Owner's Manual

V . C O M F O R T

Armrest Width Adjustment

You can change each armrest's width independently of the other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the arm
rest receiver bracket. See figure 17.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.

Armrest Height Adjustment

To change the armrest height:
1. Loosen the two setscrews located on the armrest receiver.
2. Raise or lower the armrest to the desired height.
3. Tighten the setscrews to secure the armrest.

Armrest Angle Adjustment

To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to
the floor. See figure 17.
2. Loosen the jam nut.
3. Turn the adjusting screw clockwise to raise the front
of the armrest, or turn the adjusting screwcounterclock-
wise to lower the front of the armrest.
4. Tighten the jam nut to lock the adjusting screw into place.

Controller Position

You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the rear
shroud.
3. Unplug the controller connector from the power base.
4. Remove any wire ties securing the controller cable to
the armrest.
5. Loosen the mounting screws in the controller mounting
block. See figure 18.
6. Move the controller mounting block and controller to
the other armrest and tighten the mounting screws.
26
A D J U S T M E N T S
SETSCREWS
Figure 18. Adjusting Controller Position (Standard Seat)
Figure 19. Underside of Armrest
www.quantumrehab.com
MOUNTING BLOCK
MOUNTING SCREWS
SETSCREW
Quantum 6000