Setup; Ac Power - Chauvet Colordash Block User Manual

3. SETUP

AC Power

This fixture has an auto-switching power supply that can accommodate a wide range of input voltages
(100 ~ 240 VAC, 50/60 Hz). Before powering on the unit, make sure the line voltage to which you are
connecting it is within the range of accepted voltages.
This fixture is designed for power linking from one COLORdash™ Block to another COLORdash™
Block fixture. This is done with IEC extension cables.
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0
to 100% switch.
To determine the power requirements for a particular fixture, see the label affixed to the back plate of
the fixture or refer to the fixture's specifications chart. A fixture's listed current rating indicates its
average current draw under normal conditions.
Always connect the fixture to a circuit with a suitable electrical ground.
COLORdash™ Block User Manual
8 6/19/2009 4:54 PM