Ptt To All Handsets - VTech LS6315 User Manual

Telephone operation

PTT to all handsets

You can connect a PTT call from a single handset to all available
system handsets.
1. You have four ways to begin a PTT-to-all call:
Press and hold PUSh TO TALK when the handset is not in use.
•
Press PUSh TO TALK when the handset is not in use. Then
•
press
TONe
If you have more than two handsets, press PUSh TO TALK when
•
the handset is not in use. Press /
> All handsets, then press
• If you have more than two handsets:
a) Press MeNU/
b) Press /
/SeLeCT.
MeNU
c) Press /
/SeLeCT or PUSh TO TALK.
MeNU
Your handset displays Connecting to All handsets... for a few seconds.
When the connection is made, all handsets display Press and hold [PTT]
to talk and beep once.
Press and hold PUSh TO TALK on your handset. A chirp indicates your
2.
microphone is on. Speak towards the handset. Your voice is broadcast to
all destination handsets.
While you are speaking, your handset screen shows PTT To hANDSeT X
(X represents the destination handset numbers; a maximum of four
handset numbers appear).
Release PUSh TO TALK after speaking. All handsets beep once again.
3.
After the handsets beep, you can press and hold PUSh TO TALK to
continue speaking or the destination handsets can respond (see Answer
PTT on page 26).
To end the PTT call, press OFF/
4.
telephone base or charger. The handset screen shows Push to talk
ended for a few seconds.
After PUSh TO TALK is released, the PTT call remains open for a short
time. If no one presses PUSh TO TALK within 10 seconds, the PTT call
ends automatically.
.
MeNU
when the handset is not in use.
SeLeCT
/
or
VOL VOL CID
/
or
VOL VOL CID
or
VOL VOL
/SeLeCT or PUSh TO TALK.
to highlight > Push to talk, then press
to highlight > All handsets, then press
or place the handset in the
CLeAr
25
/
to highlight
CID