Connections - Alpine TME-M740BT Owner's Manual

Bluetooth integrated vga monitor
Hide thumbs Also See for TME-M740BT:
Table of Contents

Advertisement

01GB00TMEM860.book Page 19 Monday, October 16, 2006 1:50 PM

Connections

01GB07TMEM860.fm
AUX IN (White)
AUX IN (Red)
AUX IN (Yellow)
AUX OUT (White)
AUX OUT (Red)
AUX OUT (Yellow)
CAMERA IN (Yellow)
OUT-IN
(Black/White)
REMOTE IN (AUX)
(Brown/White)
REMOTE IN (HU)
(Brown/White)
REVERSE
(Orange/White)
PARKING BRAKE
(Blue/Yellow)
ACC
(Red)
FUSE
(2A)
GND
(Black)
Audio Input Connector (AUX IN) (White)
Left input the audio.
Audio Input Connector (AUX IN) (Red)
Right input the audio.
Video Input Connector (AUX IN) (Yellow)
Input the video.
Audio Output Connector (AUX OUT) (White)
Left output the audio.
Audio Output Connector (AUX OUT) (Red)
Right output the audio.
Video Output Connector (AUX OUT) (Yellow)
Output the video.
Camera Input Connector (Yellow)
Use when connecting a back-up camera.
Audio Interrupt Out Lead (Black/White)
Remote Control Output Lead (AUX) (Brown/White)
Connect this lead to the remote control input lead. This lead
outputs the controlling signals from the remote control.
Remote Control Output Lead (HU) (Brown/White)
Connect this lead to the remote control input lead. This lead
outputs the controlling signals from the remote control.
Reverse Lead (Orange/White)
Use only when a back-up camera is connected. Connect to
the plus side of the car's reverse lamp that lights when the
transmission is shifted into reverse (R).
Switches the video picture to the back-up camera. This is
linked with putting the car into reverse (R).
Parking Brake Lead (Blue/ Yellow)
Connect this lead to the power supply side of the parking
brake switch to transmit the parking brake status signals to
the TME-M740BT.
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's fuse
box or another unused power source which provides (+)
12V only when the ignition is turned on or in the accessory
position.
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
RGB Input Connector
Connect this to the RGB output terminal of the Navigation
System.
Main monitor
Display cable / Power cable
Fuse Holder (2A)
ALPINE TME-M740BT 00-00000Z00-A (EN)
19
-EN

Advertisement

Table of Contents
loading

Table of Contents