Connecting The Sensor And Cable - YSI PRO20 User Manual

Number
1
2
3
4
5
6

CONNECTING THE SENSOR AND CABLE

CONNECTING THE SENSOR
"Sensor" refers to the removable portion or electrode sensing portion of the cable
assembly, i.e. the dissolved oxygen sensor. "Bulkhead" refers to the portion of the
cable with the single-pin connector (Figure 3).
Key
Opens Calibrate menu from the run screen if One
Use to navigate through menus, to navigate through
box options at the bottom of the run screen, and to
Press once to turn instrument on. Press a second
time to turn backlight on. Press a third time to turn
backlight off. Press and hold for 3 seconds to turn
Use to enter the System Setup menu from the run
Use to navigate through menus, to navigate through
box options at the bottom of the run screen, and to
Description
Calibrate
Press and hold for 3 seconds to calibrate.
Initiates One Touch Calibration.
Touch Calibration is disabled.
Up Arrow
increase numeric inputs.
Power and Backlight
instrument off.
screen.
Enter
Press to confirm entries and selections.
Down Arrow
decrease numeric inputs.
4
Menu