Maserati Gransport Owner's Manual page 105

Table of Contents

Advertisement

t
If the warning light
remains on,
there may be a system multifunction.
This status is also indicated by a beep
when the key is brought to the MAR
position.
WARNING: Contact your Authorized
Maserati Dealer for service to have the
cause of this malfunctioning
eliminated.
Operation with the engine
switched off
After completing the "system start-
up" stage, the gear currently engaged
will appear on the display:
– N (Idle)
– R (Reverse gear)
st
– 1 (1
gear).
If the indication is flashing (which can
also occur with N), it means that the
gear is not perfectly engaged or
disengaged; shift it to neutral (N) and
then to the desired gear.
If a horizontal dash appears
on the display, there may be
system multifunction.
With the engine switched off, all gears
can be engaged, including the neutral
(N); keeping the brake pedal pressed,
you must proceed as follows:
– N (Neutral): pull both levers found
behind the steering wheel.
– R (Reverse gear): raise and pull
joystick C away from you.
st
– 1
gear engagement: push the
joystick C forwards.
– Up-shifting: pull the UP lever (B)
towards the steering wheel.
– Downshifting: pull the DOWN lever
(A) towards the steering wheel.
To engage the reverse gear,
keep the joystick C pulled
towards the rear, until the R
signal appears on the display.
To engage the opposite gear
using the 1st gear and reverse
gear (C) joystick, keep it
pushed forward until number "1"
appears on the display.
WARNING: Release the UP, DOWN and
R levers immediately after the
gearshift request. A prolonged
maneuver could make the failure
t
warning light
and sound signal
switch on. Do not operate the system
with the engine switched off to
prevent discharging of the battery.
Avoid shifting of gears with the engine
off, to prevent overheating of the
system.
Driving the car
With the engine running, the car
stationary and the brake pedal
pressed, release the brake and press
the accelerator to start moving.
With the engine on and the car
stopped, it is possible to shift directly
st
from the 1
gear to R (reverse) using
the joystick C, and from the reverse
st
gear to the 1
gear by pushing the
joystick C forward or by pulling the
lever UP towards the steering wheel.
"Cambiocorsa" gearbox
5
105

Advertisement

Table of Contents
loading

Table of Contents