Refitting The Standard Wheel - Maserati Gransport Owner's Manual

Refitting the standard wheel

– Following the procedure described
above, lift the car and remove the
spare wheel.
– Fit the standard wheel using the
tighten studs, removed during the
disassembly procedure.
– Tighten the studs using the special
wrench.
The standard wheel must be
fitted using the specific studs
only. Put back the spare
wheel's studs into the box, to use
them again in the event of refitting
the spare wheel.
– Lower the car and remove the jack.
– Fully tighten the studs following the
6
sequence indicated before.
Observe the tightening
torque for the wheel studs
(98 ± 10 Nm).
142 If a tire gets a puncture
On completion of the operation:
– Thoroughly deflate the spare wheel,
exerting pressure on the valve
through the protruding piece of the
valve cap.
– Position the jack, the wrench with
the bushing and the special studs in
their box and put it back into the
spare wheel.
– Position the spare wheel in the
luggage compartment, close it with
its cover and secure it to the panel
with the clamping device.
– Cover the spare wheel with the
luggage compartment covering
panel.
After refitting the standard
wheel, check the tire pressure.
The jack can be used only to
replace the wheels. Never be
use it repairs under the car.