Maserati Gransport Owner's Manual page 49

WARNING: When you turn the ignition
key to the MAR position and the
does not light up or switches on when
driving the car, contact your
Authorized Maserati Dealer as soon as
possible.
Catalytic converter high
temperature warning
light
Turning the key to MAR the warning
light comes on for self-diagnosis, but
should go out after starting the
engine.
This warning light starts flashing or
comes on with a fixed light when
engine malfunction results in high
exhaust system temperature.
WARNING LIGHT FLASHING:
catalyst temperature is too
high. Reduce speed
immediately until the warning light
goes out and then drive carefully at
moderate speed. Contact your
Authorized Maserati Dealer as soon as
possible for service.
IF THE WARNING LIGHT
U U U U
CONTINUES FLASHING OR
STAYS ON AFTER HAVING
REDUCED THE SPEED: dangerous
temperature in the catalytic
converters, catalysts can be damaged.
Stop the car immediately and have it
towed to the nearest Authorized
Maserati Dealer for service.
Maserati declines all
responsibility any damage
caused from non compliance
with the above mentioned warnings.
Defective wheel anti-
lock system (ABS)
Switches on when a problem
is detected in the ABS system is
defective. The normal brake system
remains operational, but it is advisable
to contact your Authorized Maserati
Daler as soon as possible.
Front brake pads worn/
brake fluid low
Switches on when the front
brake pads reach the wear limit or the
brake fluid level drops below the
minimum level. The operation of the
warning light can be checked by
pressing the button on the brake fluid
reservoir cover located in the engine
compartment.
When replacing the front brake pads,
also check the rear brake pads for
wear.
If the warning light comes on
when the car is travelling
immediately check brake fluid
level. If fluid level is below the
minimum limit there could be a
leakage. Contact your Authorized
Maserati Dealer before restarting the
car.
Indicators and warning lights
3
49