G.swing-In/Out Hangers And Footrests; H.articulating Legrest Or Elevating Legrest; Footrest Height Adjustment; Backrest - Sunrise Medical Quickie GTX Owner's Manual

E N G L I S H
G. SWING-IN/SWING-OUT HANGERS AND FOOTRESTS
(GTX SWING-AWAY) (60º, 70º, 70ºV, 70° HEMI, 80° OR 90º)
10
1. Installation
a. Place swing-in/swing-out pivot saddle into the receiver on front frame tube with the footrest
facing outward from the frame. (
b. Rotate the footrest inward until it locks into place on locking bolt. (
2. Removal
a. To remove footrest, push release latch toward the frame.
b. Rotate footrest outward and lift.
11
3. Height Adjustment
a. Loosen set screws (O).
b. Slide footrest extension up or down inside frame tube to desired height.
c. Tighten set screws.
H. ARTICULATING OR ELEVATING LEGREST (GTX SWING-AWAY)
1. Installation
To install or remove articulating legrest (ALR) or elevating legrest (ELR) see instructions for swing-
away hangers and footrests.
2. Adjustment
a. To raise legrest, lift to desired position. Legrest will automatically lock in place.
b. To lower, while seated in chair, press release lever (A) forward and lower legrest to desired
position. Legrest will automatically lock in place.
I. FOOTREST HEIGHT ADJUSTMENT (GTX FIXED FRONT)
To adjust the height of your footrest, remove the screw (B) on both sides of the footrest. Slide the footrest
up or down to the new desired height and tighten the two screws back into place. Use a torque setting of
120 in-lbs (13.6 Nm). It is recommended that you maintain a minimum of 2.0 inches (5 cm) between the
lowest point on the footrest and the floor. Additionally, both sides of the footplate should be of equal
height.This will provide adequate clearance for uneven surfaces and prevent damage to your footrest.
To adjust angle of footrest, loosen screw (C)
Tighten screw (C) on both sides of footrest. Use a torque setting of 120 in-lbs (13.6 Nm).
NOTE– Footrest must be in locked position before riding in wheelchair.
J. BACKREST 16
1. Height Adjustment
a. Remove the backrest upholstery from the frame.
b. You will see the backrest tube which telescopes into the frame and is secured by a screw on
the side of the frame.
c. There are holes 1 inch apart that you may choose from to set the back height.
d. Remove the two backrest bolts from the rear frame tubes.
e. After selecting the proper height, insert bolt through frame and backrest tube.
f. Slide the backrest upholstery back over both backrest tubes.
10
-M)
10
15
. Change angle of footplate to desired position.
-N)
12 13
Articulating
Legrest
14 15
15
11
O
12
A
13
A
Elevating
Legrest
14
B
B
15
C
C
split footrest, if needed
16
052124 Rev. B