Single Ended Output; Status Led; Power Switch; Rear Panel Legends - Bryston BHA-1 Owner's Manual

7: SINGLE ENDED OUTPUT

Quarter inch stereo phone jack, also referred
to as a ¼ inch TRS (Tip-Ring-Sleeve) connec-
tor, or a 3 conductor ¼ inch phone jack. This
single ended or unbalanced output uses only
one of two output stages and therefore deliv-
ers only half the available power.
TIP = Left channel
RING = Right channel,
SLEEVE = ground (or common)

8: STATUS LED

Lights green when the BHA-1 is turned ON.
When the BHA-1 with the external power sup-
ply option is properly connected to an MPS-2
external power supply and the MPS-2 is turned
ON but the BHA-1 is turned OFF, the LED will
light red to indicate that external power is avail-
able.
BHA-1

9: POWER SWITCH

The UP position is ON and the DOWN position
is OFF. There is no standby mode in the BHA-
1. However, when the power switch is OFF it is
still possible to turn the unit on via the Remote
Trigger Input on the rear panel (se Rear Panel,
item 11 and also Remote Turn On on page 5).
REAR PANEL
10: IEC 60320-C14 POWER INLET
Mates with C13 power cord connector.
11: FUSE DRAWER
Turn off unit and disconnect power cord be-
fore attempting to replace the fuse. Replace
the fuse only with the same type and value as
stated on the fuse label on the rear panel next
to the fuse drawer/power inlet module.
HEADPHONE AMPLIFIER