Toshiba G8000 SERIES Installation And Operation Manual page 31

3) The UpS should not be used with a load that has a rated input that is greater than the
rated output of the UpS.
4) If using the UpS to provide power to motors that require high starting current or with
motors that require a long starting time, call Toshiba support for guidance in over
sizing the UpS for lock rotor current.
5) Do noT insert metal objects or combustible materials in the ventilation slots of the
UpS.
6) DO NOT place, hang, or paste any objects on the exterior surfaces of the UPS.
7) The capacitors of the UpS maintain a residual charge for a while after turning off the
UpS. The required discharge time for each UpS is provided via a cabinet label. wait
for at least the minimum time indicated on the label and ensure that the front panel
leD's have gone out before removing the front panel of the UpS once the UpS power
has been turned off.
8) Do noT attempt to disassemble, modify, or repair the UpS. Call your Toshiba sales
representative for repair information.
9) Turn the power on only after installing ALL of the covers.
10) Do noT remove any covers of the UpS when power is on.
11) If the UpS should emit smoke or an unusual odor or sound, turn all power sources off
immediately.
12) Warning signs should be placed on or near the load as a notification that the load is
being powered by the UpS.
13) Additional warnings and notifications shall be posted at the equipment installation
location as deemed required by Qualified Personnel.
G8000 Series with Isolated output Installation and operation manual
While operating in the inverter mode, placing the input breaker
in the "OFF" position will switch the UPS to the battery backup
mode.
The output of the UpS will continue uninterrupted to the load. The unit
must be in the bypass mode at the time that the breaker is placed in
the "oFF" position for the UpS to shutdown power to the load.
After an Emergency Power Off (EPO), DO NOT reset the breaker
until the UPS internal circuits have been fully discharged.
The UpS could be damaged if the unit is not fully discharged before
the breaker is reset.
WARNING
CAUTION
23