Sanding Belt - Grizzly H8253 Instruction Manual

Read the manual before operation.
Become familiar with this tool, its
safety instructions, and its operation
before beginning any work. Serious
personal injury may result if safety
or operational information is not
understood or followed.
Like all tools there is potential danger
when operating this tool. Accidents
are frequently caused by lack of
familiarity or failure to pay attention.
If normal safety precautions are
overlooked or ignored, serious
personal injury may occur.
To avoid accidental
disconnect the sander from the air
supply when it is not in use.
-6
-
OPERATIONS
starting,

Sanding Belt

Installing the Sanding Belt
1. DISCONNECT THE SANDER FROM
THE AIR SUPPLY!
2. Place the sanding belt over the contact
wheel, as shown in Figure 5.
Belt
Figure 5. Preparing the sanding belt.
3. Compress the contact arm shaft by
pressing the contact wheel towards
the drive wheel. Slide the belt over the
drive wheel until it is centered, then
release pressure (Figure 6).
Belt
Drive Wheel
Figure 6. Attaching the sanding belt.
Model H8253 Air Belt Sander
Contact Wheel
Contact Wheel