Connecting A Video Device (Component Video/Hdmi Device) - Mitsubishi Electric LDT55IV User Manual

P-4 Connection procedure (continued)

Connecting a video device (component video/HDMI device)

This monitor can be connected to a video device equipped with component output such as a DVD player.
Refer to the user's manual of the connected device for details. (Cables shown in the fi gure below are commercially available.)
• To connect a DVD player equipped with component output to the DVD/HD IN connector (YPbPr or YCbCr) on the monitor, use a
BNC cable (BNC x 3 – BNC x 3) and a BNC – RCA adaptor (commercially available), or a signal cable (BNC x 3 – D connector).
Select [DVD/HD] using the INPUT button on the monitor or the YPbPr button on the wireless remote control.
• To make audio connection, connect an audio cable (RCA) to the AUDIO IN2 connector or the AUDIO IN3 connector.
Select [AUDIO2] or [AUDIO3] using the AUDIO INPUT buttons on the wireless remote control.
• To connect a DVD player equipped with HDMI output to the RGB1 IN connector (HDMI) on the monitor, use an HDMI signal
cable.
Select [RGB1] using the INPUT button on the monitor or the HDMI button on the wireless remote control.
• For HDMI cable connection, select HDMI audio.
(You can select HDMI audio only when the video input is [RGB1].)
Left side of LCD monitor
AUDIO IN2 (RCA)
Front of LCD monitor
RGB1 IN (HDMI)
DVD/HD IN
(Y·Pb·Pr, Y·Cb·Cr)
HDMI cable
DVD/HD IN
(Y·Pb·Pr, Y·Cb·Cr)
BNC cable
(BNC x 3 to BNC x 3)
Signal cable
(BNC x 3 to D connector)
Audio cable (RCA)
English-20
DVD player
(HDMI device)
To HDMI output
BNC – RCA adaptor
To video output
DVD player
(component device)
To D connector output
To audio output