Connecting A Video Device (Component Video/Hdmi Device) - Mitsubishi Electric LDT323V User Manual

P-4 Connection procedure (continued)

Connecting a video device (component video/HDMI device)

This monitor can be connected to a video device equipped with component output such as a DVD player.
Refer to the user's manual of the connected device for details. (Cables shown in the fi gure below are commercially available.)
• To connect a DVD player equipped with component output to the DVD/HD IN connector (YPbPr or YCbCr) on the monitor, use a
BNC cable (BNC x 3 – BNC x 3) and a BNC-RCA adaptor (commercially available), or a signal cable (BNC x 3 – D connector).
Select [DVD/HD] using the INPUT button on the monitor or the YPbPr button on the wireless remote control.
• To make audio connection, connect an RCA cable (audio) to the AUDIO IN2 connector or the AUDIO IN3 connector.
Select [AUDIO2] or [AUDIO3] using the AUDIO INPUT buttons on the wireless remote control.
• To connect a DVD player equipped with HDMI output to the RGB1 IN connector (HDMI) on the monitor, use an HDMI signal
cable.
Select [RGB1] using the INPUT button on the monitor or the HDMI button on the wireless remote control.
• For HDMI cable connection, select HDMI audio.
(You can select HDMI audio only when the video input is [RGB1].)
LCD monitor (rear)
DVD player
(HDMI device)
Signal cable
(BNC x 3 to D connector)
BNC cable
(BNC x 3 to BNC x 3)
DVD/HD IN
(Y·Pb·Pr, Y·Cb·Cr)
G R
B
DVI IN
V H
D-SUB IN
HDMI cable
To HDMI output
English-20
To D connector output
To video output
BNC-RCA adaptor
RCA cable (audio)
AUDIO IN2 (RCA)
VIDEO IN S-VIDEO
IN2
HDMI
RS-232C IN
IN3
L R
D-SUB OUT
IN1 OUT
RS-232C OUT
VIDEO OUT
RGB1 IN (HDMI)
DVD player
(component device)
To Audio output