Conveyor Belt Replacement - Grizzly G0459P Owner's Manual

conveyor belt
Replacement
tools Needed:
hex Wrench 6mm .............................................. 1
Wrench/socket 19mm ....................................... 1
Wrenches/sockets 14mm .................................. 2
Wrench/socket 12mm ....................................... 1
Wrench 10mm ................................................... 1
phillips head screwdriver #2 ............................ 1
measuring tape ................................................. 1
gauge blocks (see Page 30) ............................ 2
Feeler gauge set .............................................. 1
assistant for lifting help ................................... 1
Flashlight or Work light ..................................... 1
Correction Fluid or paint .................................... 1
black Felt tipped pen ....................................... 1
replacing the conveyor belt is a big job and
requires moderate mechanical skill and a fair
amount of patience. For planning purposes, expect
to have your machine out of operation for at least
a few hours.
as you remove hardware to complete these
instructions, we recommend putting all the bolts,
screws, washers, etc. back into the holes from
which they came. this simple habit will take slight-
ly longer when disassembling the machine, but it
will save you a lot of time and reduce frustration
during reassembly.
to replace the conveyor belt:
1.
disConneCt poWer to the sander!
2.
remove the top cover by loosening the hex
bolts and removing the phillips head screws
(figure 40) securing the top cover support.
-38-
Qty
figure 40. locations to remove top cover
3. remove the right handle and side panel (2
cap screws and 6 tap screws).
4. remove the gear cover (2 phillips head
screws) and loosen the 2 hex nuts securing
the brace and remove it.
5.
remove the dust scoop (4 hex bolts and
4 flat washers), compression springs and
spring plates (figure 41) from the front pres-
sure roller and set the roller aside.
spring
plate
figure 41. Front pressure roller components.
mounting hardware.
Compression
spring
model g0459/g0459p (mfg. 7/11+)
neW
photo