Secure Computing SG300 User Manual page 269

Note
Local SNMP Port should be changed if you have enabled the SNMP agent under
Management -> SNMP.
Administrative Contact is the SNMP sysContact field. Any value may be specified, but
a good choice is contact information for the local administrator.
Device Location is the SNMP sysLocation field. Any value may be specified, but a good
choice is a short description of the physical location of the device.
Enter the Syslog Remote Port to which to send syslog messages. This must be the
same as the syslog_port configuration setting for CMS
Syslog Filter allows setting of a filter for syslog message which are sent to CMS.
Absolutely Everything sends all messages, including debug messages. This may
result in many messages being sent to CMS. Log Nothing sends no messages, which
can make troubleshooting more difficult. Typically, a setting somewhere between the two
is appropriate.
Click Submit to apply your changes.
SNMP
To allow external SNMP management software to query this device for management
information, check Enable SNMP Agent.
Enter the name of a community that is allowed read-only access in Read-Only
Community. You may optionally include an IP address or network to restrict who is
allowed access. You may optionally include an OID to restrict the fields that are
accessible.
Enter the name of a community that is allowed read-write access in Read-Write
Community. You may optionally include an IP address or network to restrict who is
allowed access. You may optionally include an OID to restrict the fields that are
accessible.
265
System