Sg Gateway Appliance Quick Setup - Secure Computing SG300 User Manual

SG Gateway Appliance Quick Setup

Unpack the SG unit
Check that the following items are included with your SG unit:
Power adapter
SG CD
Network cable
On the rear panel of the SG unit you will see network, serial and possibly USB ports, a
Reset/Erase button, and a power inlet.
The front panel of the SG unit contains activity LEDs (lights) that vary slightly between
models. These provide information on the operating status of the SG unit.
Note
Power is ON when power is applied (use only the power adapter packaged with the unit).
System/Heart Beat/TST flashes when the SG unit is running.
Initially, all appliance models except for the SG300 also have all other front panel LEDs
flashing.
If these LEDs do not behave in this manner before your SG unit is attached to the
network, perform a factory reset. Press the black Reset/Erase button on rear panel
twice within two seconds to restore factory default settings. If the LEDs are still not
flashing after 30 seconds, you may need to contact customer support.
Set up a single PC to connect to the SG unit
The SG unit ships with initial network settings of:
LAN IP address:
Getting Started
192.168.0.1
12