Programming Feature Keys - Hitachi SelecSet 900 Series User Manual

P
ROGRAMMING

Programming Feature Keys

Programming
feature keys
Setting your
autodial keys
as feature keys
1-24
F K
EATURE EYS
You can program your autodial keys for one-touch feature
access in two ways:
• Using a feature access code
• Using your soft key menu (SelecSet 930/940 only)
The procedure used to set your autodial keys as feature
keys using feature access codes is described here. If you
have a SelecSet 930 or 940 with a soft key menu, see
"Programming an Autodial Key"
To set your autodial keys as feature keys:
1
Decide which keys you want to program and which
features you want to assign to them.
2
Lift your handset or press <SPKR>.
3
Dial the station speed calling-register access code.
4
Press the autodial key you want to program.
5
Dial the feature access code for
the feature you want stored at this key.
6
Wait for confirmation tone (three short beeps).
Note: To re-program the key, repeat steps 1-5. The
new programming overwrites the old
programming.
HCXTD850, Rev. A02, September 2001
S S 900 U
ELEC ET SER
on page 4-24.
G
UIDE