Advertisement
1.2. Package Contents
RS232 PCI Host
This User's Manual
LINDY Driver CD
Fan-Out Cable (for 4Ports and 8Ports card only)
2.
Software Installation
After driver installation, please setup the correct Data Rate by 14.745MHz frequency or by
automatic frequency detection for proper operation.
3.1. Windows 2000/XP/Vista & Windows 7 installation
1. Power off the system. Insert PCI Card into an available PCI slot.
2. Power up the system, and insert the Driver CD into your CD-ROM/DVD.
3. Windows will display the Found New Hardware Wizard, Click "Next".
4. Select "Search for a suitable driver for my device (Recommended)" and Click
"Next", and make sure the Driver CD in your CD-ROM/DVD.
5. Under "Specify a locations" insure that is only checked, and click "Next".
6. Type in X:\ (If your CD-ROM/DVD is X:\) and click "Browse".
7. Points specify a location, example X:\51725 \Uart for 32bit OS, and click "OK".
8. When the wizard indicates that it found a driver for the device click "Next". Then click
"Finish".
9. Repeat Step 3 – Step 8.
3.2.Frequency Setting & Installation
2000/XP/Vista & Windows 7
Follow the instructions in this section to verify that the controller was installed
correctly.
1. Right click on "My Computer" icon, select "Properties", left click on "Hardware"
tab, and then on "Device Manager" button.
Verifying under Windows
Advertisement
