Hague Quality Water WaterMax 61AAN Owner's Manual And Installation Manual page 37

Assembly and Parts, Cont.
Brine Valve Housing Assembly Cont.
53511 Brine The Piston should have an O-Ring on the shaft side of the flange and a spring pressed onto a boss on
Piston the other side. The O-Ring should be free of defects such as cuts or debris on the shaft side.
53510 Housing Just inside the entrance hole for the Brine Piston (53511) is a concave seat area that must be free of
defects such as nicks, indentations, or debris. This seat area ensures a leak-free seal for the static O-
Ring on the Brine Piston. If any defects are detected by visual inspection, repair or replace as needed.
90843 0.5 gpm The Flow Button has two distinct and different sides. One is "flat"; the other is "concave." The button
Flow Control should be centered in the housing opening with the four locator "ribs" with the concave side facing the
Housing End Cap (93247).
93247 Housing The Cap is held in place by two 3/4" thread cutting screws that engage the Housing flange. An O-Ring
End Cap seals the Cap and Housing. Place the O-Ring into the housing opening, lubricate with silicone grease
and then using a twisting action, pressure insert the Cap.
Caution: The 3/8" locking clip (200199) must be installed to prevent air from being drawn into the
appliance during brine rinse.
WaterMax 60 Series Owner's Manual 4/29/2008 37