Culligan Estate 2M Installation And Operating Manual page 11

• Loosen the screw and lift the white time-of-day dial and
rotate it until the desired time of recharge is opposite the
peg (H). Please note that whenever the time of recharge is
changed, the time-of-day setting may be changed also.
TIME OF DAY
Upon completing the installation, the timer must be set to the
correct time of day. Time of day must also be reset after any
kind of power interruption, such as that caused by an
electrical storm. See Fig. 8.
• Determine the correct time of day.
• Grasp the gear (K) and lift straight up (the white time-of-
day dial will lift with it). Rotate the gear until the correct
time of day lines up with the pointer (P). The dial is spring-
loaded and will return its position when released. Make
sure the teeth mesh.
Note that the silver half of the time-of-day dial designates
the daytime hours, while the black half designates the night-
time hours.
GUEST CYCLE
An extra recharge can be initiated any time extra soft water is
required by pushing the Manual Recharge lever (M) in the
TABLE 2A — CULLIGAN ESTATE 0.7FT
*Persons
in 0-7 8-14
Household
(0-120) (121-240)
1
2
5 5
1
3
5 7
1
4
5 5
1
5
5 5
1
6
7 9
2
7
5 5
2
8
5 7
2
9
5 9
2
10
5 12
*In household application, not recommended for over 10 people because of pressure drop limitations.
3
WATER CONDITIONER SALT DOSAGE — FREQUENCY
Total Water Hardness in Grains Per Gallon (mg/L) as Calcium Carbonate
15-21 22-28
(241-360) (361-480) (481-600)
1 1 2
7 5 6
1 2 2
5 7 6
2 2 3
7 6 9
2 3 3
5 9 5
2 3 6
8 5 6
3 6 6
5 5 8
3 6 6
5 6 9
3 6 6
5 7 13
3 6 6
5 9
direction of the arrow, then releasing. The unit will still
recharge at its regular frequency as determined by the meter
device. On models with meter control, the red button (X) must
also be pushed briefly before the recharge cycle can begin.
SERVICE POSITION
The timer assembly is in the service position when the tooth-
less notch in the cam gear is over the teeth on the idler gear
(L). The timer will return to this position after each recharge
(Fig. 8).
TIME CLOCK SETTINGS
To set the Estate
®
determine the hardness of the water along with the number of
people in the household. Refer to Table 2. Locate the row
corresponding to the number of people in the home and move
across to the appropriate hardness column. The number in
the shaded region is the salt dosage. The other
number is the frequency of regeneration.
SALT DOSAGE
To set the salt dosage, refer to Fig. 8. Loosen screw (A) and
rotate outer dial until the salt dosage dial line up with the
indicator mark (D). Tighten screw (A).
29-35 36-42 43-49
(601-720) (721-840)
2 3 3
5 6
3 3 6
9 5
3 6 6
5 6
6 6 6
7 9
6 6 6
9 12
6 6
12
6
6
2 water conditioner for optimal performance,
50-56 57-63 64-75
(841-960) (961-1080) (1081-1280)
3 3
8 9 5
6 6
5 6 8
6 6
8 9 12
6 6
12 13
Water
Usage
Gal. (Litres)
per day
6
150(570)
6
225(850)
6
300(1135)
375(1420)
450(1705)
525(1990)
600(2270)
675(2555)
750(2840)
/ 9
SETTINGS