Playing A Disc; Pausing Playback (Still Mode); Stopping Playback; To Skip To A Different Track - Venturer PVS122B Owner's Manual

Basic playback
This owner's manual explains the basic instructions of this unit. Some DVD
discs are produced in a manner that allows specific or limited operation
during playback. Such as, the unit may not respond to all operating commands.
This is not a defect in the unit. Refer to the instruction notes of discs.
" " may appear on the screen during operation. A "
desired operation is not permitted by the unit or disc.

Playing a Disc

1. Slide the POWER ON/OFF switch on the left side of unit into on mode.
See CUSTOMIZING THE FUNCTION SETTINGS (page 23 to 26) before proceeding
to step 2.
2. Slide the OPEN switch to open the disc door.
3. Hold the disc by its sides and carefully make it fit onto the central support of
compartment with the label side facing up until you hear a "click".
4. Close the disc door.
It takes a short while for your unit to load the disc. After loading, for some discs,
the unit will automatically start playback of the disc.
5. Press the PLAY button.

Pausing playback (still mode)

II
Press the PAUSE button. To resume normal playback, press the

Stopping playback

Press the STOP button at the location where you want to interrupt playback. To
resume playback at the position where the disc was stopped, press the
button.
If you press the
the PLAY button will reset the disc to the beginning.

To skip to a different track

• Press the
previous track.
• Press the
• For audio CD disc, use the number buttons (remote control only) to jump straight
to that track number.
PLAYING A DISC
DVD CD
STOP button twice, the unit's memory will be cleared and pressing
PREV button repeatedly to skip to the start of the current or
NEXT button to skip to the next track.
E - 16
" means that the
PLAY button.
PLAY